American Car Craft Mustang Fender Top Caps Polished Illuminated V6 & GT 5.0 2005-2009 User Manual
Page 2
caps. You will notice that there is one bolt towards the center area that sort of sits into a recess. You
have been provided with two thick small washers, for each side, that has been provided to be placed
under this one bolt location. This will allow that bolt to sit a little higher when tight allowing the new
fender cap to run down the fender nice and smooth without any dips in that area.
2. With all four bolts in place on both sides of your engine bay you can now place the fender caps in place
and align the holes. Loosely set the ½’ 6/32 stainless truss head screws provided into each of the four
holes and into each bolt head. Then tighten down the screws.
3. You have been provided with eight 1” decorative chrome screw caps that each contain a mounting
Velcro donut. Peel the protective liner from the fender caps and then detach the Velcro donut from
each of the caps. Peel the release liner from the back of the donut and then place that donut around
each of the screw heads. Then simply place the decorative cover over the screws to finish the
installation.
4. If you fender caps are the lighted version. Simply route each length of wire emanating from the ends of
the two caps over to the battery area. These will allow you to connect the led lighting to any twelve
volt source you create such as a mercury switch/ toggle/ remote etc.
If any questions occur during installation please call American Car Craft at 727-861-1500.
Thank you for your purchase!
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520