American Car Craft Corvette Air Capacitor Cover 2Pc Perforated 2008-2013 C6+GS User Manual
Page 2
this step is skipped or not performed thoroughly is will be very probable that the cover will pop up somewhere
compromising the entire installation.
4. Now that you have achieved a nice contoured shape you can now install the part by removing the red release
liner from the back of the cover and then carefully set it in place pressing very firmly along the edges to set the
bond. It is important to allow the cover to set overnight to allow the bonding of the attachment tape to cure
before being subject to heat expansion. This will allow a good long term bond. The lower section installs in
much the same way however because of the placement, setting it just right can be a little tricky so go slowly so
that you can set it perfectly the first time. The attachment tape is very aggressive and will not allow you to
reposition it without damaging it. Remove the protective liners to finish the installation.
If any questions occur during installation, please contact American Car Craft at 727-861-1500.
Thank you and enjoy your new purchase!
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520