American Car Craft Camaro Rear Valance Trim - Classic Chrome 2010-2013 - Manual (Page 2)

1. Thoroughly clean the upper rail of the factory valance. Scrub the area with
alcohol to remove all wax and dirt then swipe the area once with the adhesive
promoter packet provided.
2. You will notice that the trim has been precut to a slight angle. Match this angle to
the valance to determine the right side up. Peel a small length of the red release
liner from the back of the trim to create a pull tab. Set the end into position and
then press firmly against the trim to create a good bond as you pull the liner along
its length until the entire trim is set into position. Use a soft cloth to firmly set the
trim in place then remove the protective liner to finish the installation.
DO NOT GET WET FOR 24 HOURS!
If you have any questions during installation please call American Car Craft at
727 861-1500.
Thank you and enjoy your purchase!
Care and Maintenance:
Wash and wax molding kits regularly to insure a beautiful long lasting finish.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com