American Car Craft Camaro Plenum Cover Brushed_Polished 2010-2013 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
2010 CAMARO LS3 CUSTOM PLENUM SHROUD COVER
PART#103035
Parts Included
4x ¼” 20 Clip Nuts
4x F lat Head Bolts
4x 5/16’’ Stainless Washers
4x Yellow spacers
Illuminated Versions Only Below
1x Red and Black 5amp Fused Wire Harness
4x Zip ties
Introduction: This new and unique accessory has been designed to expose the factory plenum cover allowing you to
paint the factory plenum or chrome plate it for an even more custom look.
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in place until
the installation is complete to prevent finger prints and or possible scratches during installation.
In order to install this part you will need to follow the engine wire tuck procedures on the following page. This will
explain how to rearrange a few things so that you will have a nice neat engine set up prior to this installation.