American Car Craft Corvette Belt Tension Cover Polished 1997-2004 C5 & Z06 User Manual
American Car Craft For the car
AMERICAN CAR CRAFT INSTRUCTION
C5 CORVETTE BELT TENSION COVER
PART# 033044
patent pending
ITEMS NEEDED: PARTS INCLUDED:
Clear Household Silicone 3/8.3/4 Bolt
121 Chrome Cap
1. You will notice a small tab sticking up at one end of your new cover. Insert this
tab behind the engine throttle body and just under the sensor connector.
2. Next locate the bolt hole just by the large tab at the opposite side of the cover.
Line this up and screw in with the bolt (provided) just slightly. At this time check
and see that you have adequate clearance between the belt tension cover and the
belt tension pulley. You should have about a finger size space between them. If
the cover is too close to the pulley remove and adjust shape by gently curving the
cover until you have provided the accurate amount of space between the two.
Once this is achieved replace bolts and tighten.