American Car Craft Camaro Exhaust Trim Rings Polished Chopped Oval w_Polished Exhaust Tips 2010-2013 User Manual
Page 2
1. Slip the new tip over the factory tail pipe as far back as it will go or as far back as
you would like it. Rotate the tip to your liking and then pilot one of the two far
back holes on the under side of the new tip with a 3/16’’ drill bit.
2. You have been provided with two ½” long 3/16
th
stainless rivets for each tip.
Once you have one hole piloted set one of the rivets into the hole and then set it
with your rivet tool. Once you have the first rivet installed drill the second hole
and then insert and install the second rivet to finish the tip installation. The
remaining hole close to the tips end is a weep hole for condensation. Repeat the
installation procedure for the remaining tip to finish the installation.
3. You have been provided with two stainless exhaust trim rings. These rings are
designed to fit directly to the factory rear valance. Oval in shape their placement
will be self evident.
4. Thoroughly scrub clean the oval area over each of the two exhaust tip openings
with household rubbing alcohol to remove any and all dirt and wax.
5. Next swipe the two areas with the adhesive promoter provided. IMPORTANT:
Before you permanently stick the new trim rings, place them in position to
determine how to shape them so that the contour to the factory valance
perfectly. Doing this will prevent lifting long term. Once you are satisfied with
the shape and contour of the rings simply peel the red release liner from the
back of the rings and then carefully position them in place pressing firmly to set.
If any questions occur during installation please contact American Car Craft @ 727
861-1500
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com