American Car Craft Hummer H2 Hood Panel 7Pc Polished_Brushed Flame Etched 2003-2007 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
HUMMER H2 HOOD PANEL 7PC FLAME ETCHED
PART #493009
PARTS INCLUDED:
7pc Stainless Hood Panel
12- Adhesive Promoter Packs
2- Tubes of Silicone
8-Decorative Chrome Top Hat Style Bolt Covers
INTORDUCTION: This all new stainless steel accessory is a truly special kit you will be proud to show off. It is a kit that
will customize an area of your HUMMER never before available and will bring your show piece to an all new level.
PROTECTIVE LINER INFORMATION: Your new accessories will come to you with a protective surface liner. Leave this
liner in place until the installation is complete to prevent finger prints and/or possible scratches during installation.
1. The first step will be to prepare your HUMMERS under hood area to receive the new covers. Remove the under
hood insulator/liner if so equipped. (NOTE: The hood insulator will not be reused and the new stainless liner will
provide an adequate thermal barrier.). The nature of this new kit is to stick to the surface of your hood so you
will need to thoroughly scrub clean the entire under hood surface to remove any and all road grime and dirt. In
most cases you will need to blow off any loose dust and dirt before you begin to scrub the areas with alcohol.
Your under hood area is relatively large so take your time to do this job thoroughly and completely. The success
of the entire installation depends on your diligence here.
2. Now that you have successfully cleaned the areas scuff the entire surface with a scotch pad and or sand paper to
increase the surface areas of all the attachment points. This is important do to the large size of all the sections.