American Car Craft Challenger Hood Plate Polished Plain Front 2008-2013 User Manual
American Car Craft For the car

AMERICAN CAR CRAFT INSTRUCTION
FRONT PLAIN UPPER HOOD PLATE
PART # 153004
This unique hood plate will nicely trim the front barren part of the challenger hood
adding that true custom look to what otherwise looks very plain.
PARTS INCLUDED:
___1-Stainless Front Hood Plate
___1-Adhesive Promoter Pack
Your cover comes to you with a protective liner. Do not remove liner until installation is
complete.
1. Thoroughly clean the area of the hood to be mounted with alcohol to remove any
road grime and wax. Then swipe the entire area with the adhesive promoter
provided. This will insure a nice permanent bond of the panel to the hood.
2. Mark the hood at the very center using the hood catch bar as a guide.
3. Mark the new panel at the very top edge also at center. Place the new panel at
these two marks so that you will be able to see just how you will need to shape the
panel to the hood. The panel is made of a 20ga thin stainless and will allow you to
gently roll and shape the panel by hand until you have achieved a nice flush
sitting contour of the hood. You will notice that the hood has a soft contouring
shape to it and it is IMPORTANT to match the shape making the panel look even
on both sides. This process will take SEVERAL attempts to make it sit just right
so you need to be patient.