American car craft – American Car Craft Corvette Doorsills Polished Stainless 2Pc 1988-1996 C4 User Manual
Page 2
Your new doorsills are designed to fasten over the two carpet screw areas.
1. Remove the two factory screws. Note: These will not be reused. Place your new
sill in position over the two holes. Using two of the three screws (provided) for
each side, fasten securely. Be sure NOT to OVERTIGHTEN as this will distort
the metal. Note: It is important that the flat head screws seat flush in the sills.
2. Drill the remaining hole with a 9/64
th
drill bit and install the final screw. Remove
the protective liner.
3. You have been provided with two molding strips, use one of them and place it
over the screws to finish this part of the installation. DO NOT CLOSE YOUR
DOOR.
4. In order to create adequate clearance for your new sills it will be necessary to
remove the five screws holding your lower carpet to your door panel. You have
been provided with 5 replacement screws that will sit deeper into the door panel
grommets thus creating adequate clearance.
5. Repeat steps one thru four for the opposite sill.
If any questions occur during installation, please contact American Car Craft at
727-861-1500
Thank you and enjoy your new purchase.
Note: Care must be taken when cleaning your new sills. It is a good idea to lightly
dust your sills with a clean soft cloth (or a clean California style duster) first in
order to prevent any particles from scratching them. (NOTE: Once this metal is
scratched it can not be repaired so please use extra care when cleaning these sills.)
Then spray and wipe (using a new clean soft cloth or lint free paper towels) with a
good quality streak free glass cleaner.
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520