American car craft – American Car Craft HHR Front Bumper Cap Polished 2Pc 2006-2012 User Manual
Page 2
2. You will notice a center point in the bumper. Accurately mark this center point with a
fine pen or pencil. Place either side of the sectional cover in place to familiarize yourself
with the placement, and just how you will set the part in position.
3. Once you are clear on the placement remove the red release liner from the back of the
cover and set it directly to the center mark and carefully place the cover into position.
Apply the opposite side in exactly the same way. Press firmly along the entire installation
to set the part then remove the protective liner. Apply a bead of adhesive promoter tube
along the edge of the cover directly to the paint. You have been supplied with a length of
chrome trim. This trim is to be used to finish the edge of the cover. Peel a small length of
the red release liner from one end of the trim and set in position so that the trim caps the
edge of your stainless cover and work your way around to the opposite side then snip off
any excess trim with a scissor and press firmly along the entire length to set.
If any questions occur during installation please contact American Car Craft @
727-861-1500.
Thank you and enjoy your purchase!
Note: EXTRA CARE must be taken when cleaning your stainless trim. It is a
good idea to lightly dust your trim with a clean soft cloth first in order to prevent
any particles from scratching it. Then wipe (using a new clean soft cloth) with a
good quality streak free glass cleaner.
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520