American Car Craft Dodge Viper Sport Seat Trim Plates with Viper Head Logo 2Pc Polished 2003-2010 User Manual
Page 2
Isopropyl Alcohol (or rubbing alcohol) found at most grocery stores and
all hardware stores. Scrub the area vigorously to remove any dirt or oil.
2. Once properly cleaned take the piece of test strip tape included and
remove a portion of the back red liner. Stick the test tape strip to the
area where you will be mounting your new trim. Test several areas. If it
is tacky and sticks then proceed to the next step. If it is not sticking
very well in any of the spots you tested then re-clean the area until the
test strip sticks to all areas.
3. Take your trim piece and without removing the back red liner - hold it
up to where it is to be mounted. See how it fits. If the piece does not
fit properly - STOP. Call us.
Become familiar with the way it fits into place. Now peel off the clear
plastic top liner (if there is one).
4. Take the Adhesive Promoter Pen or packet and open it. Swab the area
where you are going to mount your trim with the clear liquid. It will not
stain or harm your car body or interior. It is designed to help the trim
piece stick better to the surface. Let dry for 2-3 minutes.
5. Remove the red back liner and hold the trim piece slightly above where
it is to be mounted. Do not touch it to the surface yet. Carefully
maneuver the trim to the exact spot and gently set it into place without
pressing on it. Make any final adjustments necessary. Repeat steps
1-5 for the other trim.
6. Now push along the entire surface starting in the center and working
your way out. Keep the trim clean with a mild glass cleaner.
If any questions or problems occur during installation, please contact American Car Craft at 727-861-1500.
Thank You and Enjoy Your Purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520