American Car Craft Corvette Stingray Exhaust Filler Panel NPP+Dual-Mode+Bi-Mode Exhaust Brushed Illuminated 2014+ C7 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C7 CORVETTE NPP/BI-MODE EXHAUST PORT FILLER PANEL – BRUSHED
PART #052002-ILLUMINATED
PARTS INCLUDED:
1-main upper filler panel (with 60” led wire attached if illuminate)
1-lower filler panel insert
2-3/4” - 6MM flanged head replacement bolts
1-adhesive promoter packet
2-chrome bolt caps
Lighted option
2-red but connectors
2-zip ties
INSTALLATION INSTRUCTIONS
The C7 exhaust port filler panel is designed to fit around the factory exhaust tips and will offer a nice clean finish hiding
the mufflers as well as creating a cool custom look.
Liner info: Your new accessories will come to you with a protective surface liner. Leave this liner in place until the
installation is complete to prevent finger prints and or possible scratches during installation. This liner is required to
remain on the part until you are instructed to remove it.
1. The first step for this installation will be to protect the surface area of the exhaust port opening. Apply masking
tape to the upper side of the opening. Since the new panel will need to be forced over the exhaust tips and
through the opening this masking tape will insure that no scratches will occur during that procedure. Then scrub
clean the lower area of the opening to remove any road grime and dirt. This will allow a nice and easy
installation of the kits lower section.