American Car Craft Corvette Stingray Front Lip Spoiler Polished 2014+ C7 User Manual
American Car Craft For the car
AMERICAN CAR CRAFT INSTRUCTIONS
C7 Corvette Stingray Front Lip Spoiler Liner
PART#052057
1-16Ga 304 stainless steel lip spoiler
1-lenth of 1/4” chrome finishing trim
4-oem style black 9/32washer sheet metal screws
2-flat nuts
2-black ½ washer head sheet metal screws
1-small scuff pad
1-packet of adhesive promoter
1-promoter pen
1- The first step for this installation will be to lift the front of your corvette about a foot off
the ground. Set it down on a pair of jack stands for safety. Remove all of the screws that
run along the front area that secure the bumper cover.
2- Prep the surface area close to the front edge by scrubbing it with alcohol. This will
remove any and all road grime and any possible wax. Then scrub it again with the small
scuff pad supplied with the kit. Swipe the dust that was created with alcohol. At this
point you will need to check the tack. Apply a few lengths of masking tape along the
front edge. If the tape seems to stick pretty well, apply a single swipe of the adhesive
promoter supplied with your kit. This chemical is not a cleaner but an adhesive
accelerator. It is critical if you are to expect a good, long term bond of the new lip
spoiler.