Gatco 4143-Jewel Euro Tissue Holder in Chrome - Manual

PREPARATION
Tools Required for Assembly: (Not included)
• Pencil
• Electrical drill with 5/16 in. drill bit
• Hammer
CAUTION: Drywall anchors are for drywalls only. Use tile anchors for tile surfaces. (Not included)
INSTALLATION INSTRUCTIONS
1. Hold the item (A) up against desired position on wall, and outline the back
plate with a pencil. (Fig. 1)
2. Position a mounting bracket (B) in the center of outlined back plate.
Use a pencil to mark positioning of the screw holes. (Fig. 2)
3. Drill 5/16 in. pilot holes into the wall where the drywall anchors (D)
will be inserted.
4. Pinch drywall anchors (D) two wings together (Fig. 3), and insert it into the
hole horizontally. Tap flush with the wall using a hammer.
5. Insert the red push pin (E) into the drywall anchors (D)
until the wings pop open. (Fig. 4) Then remove the pin.
Do not tap the red push pin with hammer.
6. Place the mounting bracket (B) over the drywall anchors (D).
Insert mounting screws (F) through the bracket and anchors,
and then tighten firmly with Philips head screwdriver. (Fig. 5)
7. Secure the end piece (A) with Allen wrench (G) and set screw (C). (Fig. 6)
CARE AND MAINTENANCE
To maintain the beautiful luster finish, please use soft damp cloths when
cleaning and never use any cleaning solvents.
• Philips head screwdriver
• Safety glasses
1
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5 Side View
a. b. c.
a. b.
Fig. 6
GENERAL INSTALLATION INSTRUCTION
TOWEL RING, ROBE HOOK, TISSUE HOLDER(EUROPEAN STYLE)
SOAP HOLDER, TUMBLER&TOOTH BRUSH HOLDER
Top View
Push
B
D
F
B
C
G
A
B
D
D
E
Front View
A