Gatco 4149S-Jewel Tilting Rectangular Mirror in Chrome - Manual

• Philips head screwdriver
• Tape measure
1
• Level
• Safety glasses
7.Unscrew the screws (f)
from the molly bolts.
Molly bolts will remain in the
wall. (Fig. 4)
8. Place the mounting bracket
(C) over the molly bolts (F).
Insert the screws (f) back
through the bracket and the
molly bolts, then tighten
firmly with Philips head
screwdriver. (Fig. 5)
9. Secure the end piece (A)
with Allen wrench (G) and set
screw. (D) (Fig.6)
10. Tilt the mirror (B) at the
desired angle and tighten the
pivoting brackets (A)
using the Allen wrench (G)
and set screws (D). (Fig. 7)
1. Slide on left and right
pivoting brackets (A) to the
oval mirror (B) at the
mounting plate. Tighten
mirror bracket set screws (E)
firmly by hand using
a Philip head screwdriver.
(Fig. 1)
CAUTION: Do not use
electrical drill/screwdriver to
tighten the mirror bracket set
screws as it may damage the
products.
2. Hold assembled item up
against desired position on
wall, and outline the back
plates of end pieces with a
pencil. Use a measuring tape
and a level for accuracy.
(Fig. 2)
3. Position a mounting bracket
in the center of outlined back
plate. Use a pencil to mark
positioning of the screw holes.
4. Drill 5/16 in. pilot holes
into the wall where the molly
boltswill be inserted
using an electrical drill.
5. Tap molly bolts into the
pilot holes using a hammer.
6.Use an electrical screwdriver
to tighten the screws.
This will collapse the molly
bolts (F) tightly to the wall.
(Fig. 3)
PREPARATION
Tools Required for Assembly: (Not included)
• Pencil
• Electrical drill with 5/16 in. drill bit
• Hammer
CAUTION: Molly bolts are for dry walls only. Use tile anchors for tile surfaces. (not included)
CAUTION: Two people are required to safely install this oval mirror. The mirror will break if dropped.
Take extra precautionary measures to ensure a secure grip on the parts.
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
To maintain the beautiful luster finish, please use soft damp cloths when cleaning and never use any cleaning solvents.
GENERAL INSTALLATION INSTRUCTION
MIRROR
Fig. 1
Back View
B
A
C
Front View
Fig. 2
F
Fig. 3
Side View
A
E
f
Fig. 4
f
F
Fig. 5 Side View
Fig. 6
C
G D
A
B
Side View
Fig. 7
B
A
D
G