Gatco 4144-Jewel 24" Double Towel Bar in Chrome - Manual

PREPARATION
Tools Required for Assembly: (Not included)
• Pencil
• Electrical drill with 5/16 in. drill bit
• Hammer
CAUTION: Drywall anchors are for drywalls only. Use tile anchors for tile surfaces. (Not included)
INSTALLATION INSTRUCTIONS
1. Hold assembled item up against desired position on wall,
and outline the back plates of end pieces with a pencil. (Fig. 1)
Use a measuring tape and a level for accuracy.
2. Position a mounting bracket (C) in the center of outlined back plate.
Use a pencil to mark positioning of the screw holes. (Fig. 2)
3. Drill 5/16 in. pilot holes into the wall where the drywall anchors (E)
will be inserted.
4. Pinch drywall anchors (E) two wings together (Fig. 3),
and insert it into the hole horizontally.
Tap flush with the wall using a hammer.
5. Insert the red push pin (F) into the drywall anchors (E)
until the wings pop open. (Fig. 4) Then remove the pin.
Do not tap the red push pin with hammer.
6. Place the mounting bracket (C) over the drywall anchors (E).
Insert mounting screws (G) through the bracket and anchors,
and then tighten firmly with Philips head screwdriver. (Fig. 5)
7. Secure the end piece (A) with Allen wrench (H) and set screw (D). (Fig. 6)
8. Repeat 2-6 for the other end piece, and insert the bar
tubing into the end pieces. Secure the other end piece with
Allen wrench and set screw.
CARE AND MAINTENANCE
To maintain the beautiful luster finish, please use soft damp cloths when
cleaning and never use any cleaning solvents.
• Philips head screwdriver
• Tape measure
1
• Level
• Safety glasses
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5 Side View
a. b. c.
a. b.
Fig. 6
GENERAL INSTALLATION INSTRUCTION
TOWEL BAR, DOUBLE TOWEL BAR, TISSUE HOLDER (TRADITIONAL)
Top View
Push
C
E
G
C
H
D
A
B
A
C
E
E
F
Front View