Gatco 6641-Latitude2 8" Widespread Faucet in Chrome - Manual

GENERAL INSTALLATION INSTRUCTION
Latitude2 Widespread faucet
E
D
F
G
A
B
C
PREPARATION
Tools Required for Assembly: (Not included)
• Teflon tape
• Plumber’s putty
CAUTION: Before removing old faucet, turn off the cold and hot water supply lines and open the
old faucet to release pressure build-up.
CAUTION: When installing new faucet, tighten connector nuts first by hand, then use a
wrench to tighten the fitting.
CAUTION: Use Teflon tape on all threaded connections.
INSTALLATION INSTRUCTION
• Philips head screwdriver
• Pliers
Shut off water supply lines and remove old faucet.
Remove the tee connector, and spout mounting hardware from spout. Place spout
through center mounting hole in counter top / sink.
From beneath the counter top/sink, secure the spout with rubber washer (A), metal
washer (B) & locking nut (C). The openings of the washers should be facing back
where pop-up drawin pull will be inserted.
To properly lock spout in place hand tighten locking nut (C) till snug then align the
spout and use a plier to lock nut in position.
Wrap the spout shank with Teflon/ Plumbers tape. Then place the tee connector
washer (D) and cone washer (E) tapered side up inside the sealing nut (F). Insert tee
connector (G) onto the end of the spout shank. Tighten sealing nut (F) to seal.
In most cases the sealing nut will be already attached to the tee connector and
should just be tightened to ensure no leaks.
1