Peerless-AV FPE42F-S - Installation - Manual (Page 13)

13 of 16 ISSUED: 07-16-10 SHEET #: 061-9050-7 08-07-12
Hook adapter brackets ( B) onto wall plate (J) then
slowly swing display in as shown in figure 7.1.
Remove 3" serrated washer head screws from
bottom of rear supports.
7
• Always use an assistant or mechanical lifting equipment to safely lift and position the flat panel displays.
WARNING
DEtAIL 5
fig. 7.1
B
J
J
B
Swing rear supports up to access safety/security
screws as shown in figure 7.2. Turn safety/security
screws, using 4 mm allen wrench ( L), clockwise
at least six times to prevent display from being
removed as shown in detail 5. NotE: To lock the
display down, tighten safety screws to wall plate as
shown in detail 5.
Route cables through ROXTEC cable seal and plug
into appropriate connection. Reinstall 3" serrated
washer head screws and locknuts to bottom of rear
supports. Tighten all fasteners.
fig. 7.2
Mounting Flat Panel Display
3" SERRATED WASHER
HEAD SCREWS
• Do not postion AV and power cables close to heater
or damge to cables may occur. See next page for
more information.
CAUtIoN