Peerless-AV FPE42F-S - Installation - Manual (Page 8)

8 of 16 ISSUED: 07-16-10 SHEET #: 061-9050-7 08-07-12
NotE: The installed display should allow a 1/2" air gap between the front of the display and the interior surface of
the window. A display mounted directly against the window will create a dead air space that traps heat which may
affect the funtionality of both the display and the enclosure mount.
Measure the depth of your display. Choose the appropriate fixed stop-position from the chart below. Reinstall rear
supports with 3" serrated washer head screws and locknuts into appropriate fixed stop-position as shown in figure
4.1. NotE: Be sure "UP" arrow of rear support is pointing up as shown in figure 4.2.
Do not tighten fasteners.
• Failure to allow this space for air circulation and to allow heat to dissipate from the display may effect the visual ap-
pearance and/or cause damage to your display.
WARNING
Depth Adjustment
FIXED STOP-POSITION #1
FIXED STOP-POSITION #2
FIXED STOP-POSITION #3 FIXED STOP-POSITION #4
FIXED STOP-POSITION #5
4
Depth of Display Fixed Stop-Position
1-1/8" - 2-1/8" (29 - 54 mm) #1
1-3/4" - 2-3/4" (44 - 70 mm) #2
2-3/8" - 3-3/8" (60 - 86 mm) #3
3" - 4" (76 - 102 mm) #4
3-5/8" - 4-5/8" (92 - 117 mm) #5
PRoFUNDIDAD DE LA PANtALLA
PoSICIÓN FIJA DE
DESCANSo
1-1/8" - 2-1/8" (29 - 54 mm) #1
1-3/4" - 2-3/4" (44 - 70 mm) #2
2-3/8" - 3-3/8" (60 - 86 mm) #3
3" - 4" (76 - 102 mm) #4
3-5/8" - 4-5/8" (92 - 117 mm) #5
PoSItIoN D'ARRÊt FIXE
PRoFoNDEUR DE
L'ASSEMBLAGE
1-1/8" - 2-1/8" (29 - 54 mm) #1
1-3/4" - 2-3/4" (44 - 70 mm) #2
2-3/8" - 3-3/8" (60 - 86 mm) #3
3" - 4" (76 - 102 mm) #4
3-5/8" - 4-5/8" (92 - 117 mm) #5
fig. 4.1
fig. 4.2
REAR SUPPORT
LOCKNUT 3" SCREW