Peerless-AV FPE42F-S - Installation - Manual (Page 7)

7 of 16 ISSUED: 07-16-10 SHEET #: 061-9050-7 08-07-12
Installation to Wood Stud Wall
NOTE: This step is for mounting enclosure assembly (A) flush against supporting surface. For use with
mount, follow instructions provided with wall mount.
Use a stud finder to locate the edges of the studs and draw a vertical line down each stud’s center. Place enclosure
assembly ( A) on wall as a template, level and mark the center of the six mounting holes. Make sure that the
mounting holes are on the stud centerlines. Drill six 5/32" (4 mm) dia. holes 2.5" (64 mm) deep. Make sure that the
enclosure is level and secure it using six 2.5" wood screws ( C) and six washers (E) as shown in figure 3.1.
NotE: If cord cover plate assembly (K) is used on the rear of the enclosure, you may use the 1/2" spacer (M)
between enclosure assembly and wall surface.
Skip to step 4.
• DO NOT lift more weight than you can handle. Always use an assistant or mechanical lifting equipment to safely lift
and position enclosure assembly ( A).
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that the enclosure assembly is firmly attached, but do not overtighten. Overtightening can
damage the screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lbs. (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs.
Installers are responsible to provide hardware for other types of mounting situations.
3
WARNING
fig. 3.1
C
E
A