Ingalls 93306 - Manual (Page 3)

Ingalls Engineering Co., Inc. ● 2011 Cherry Street, Suite 104 ● Louisville CO 80027
(800) 641-9795 ● (303) 665-7800 ● Fax: (303) 665-7810 ● www.ingallseng.com
the axle bracket first, and then insert into the chassis mount. Just as with the OEM bar, the new bar
is very tight going into the chassis mount and may require you to use a pry bar. You may also have
to turn the bar to adjust the length one way or the other, which can be done as long as the jam nuts
are loose.
Step 5: Torque the bolts at the mounting brackets on each end first,
but make sure to leave the jam nuts on the forged ends loose. At the
axle mount, you will use the supplied, longer 14mm bolt and washer.
Insert the large silver spacer into the OEM mounting bracket and
slide the bolt through the assembly and tighten with 14mm washer,
lock washer and nut. You will reuse the OEM bolt at the chassis.
Setting the length of the new panhard bar is critical and should be
done using an alignment machine for accuracy, but you can eye it
first to get close. Be sure that the axle assembly is as centered
under the car as possible before driving. The panhard bar can be
turned by using a 22mm wrench on the flats machined into the bar.
Firmly tighten the jam nuts at each end of the panhard bar before
driving.
Note: Once the length has been set, you may want to remove the bar and tighten the jam nut at the
chassis bracket because the clearance is very tight for a wrench, however it can still be torqued after
installation if you are using an open-end wrench. Check the panhard bar after driving 100 miles or
so. The suspension may settle if you make other modifications such as coil springs, which could
change the suspension geometry and effect how the axle sits under the chassis.
Limited Warranty
Subject to Disclaimer. All Ingalls products are warranted against defects in materials and workmanship for ninety (90) days from date of purchase.
During the warranty period, Ingalls will repair, or at its option replace at no charge, components that prove to be defective. The product must be
returned, shipping prepaid, to Ingalls facility. This limited warranty does not apply if the product is damaged by accident or misuse. The foregoing
warranty is in lieu of all other warranties expressed or implied including but not limited to any implied warranty of merchantability, fitness, or adequacy for
any particular purpose or use. Ingalls shall not be liable for any special, incidental or consequential damages whether in contract, tort, or otherwise
resulting from the use or the inability to use the product.
Warranty Disclaimer
Use of this product in competition, or use on vehicles altered from original manufacturer’s specifications or settings, EXPRESSLY VOIDS WARRANTY.
The user is urged to inspect for suspension binding or interference when the product is used in these manners. However, due to the varying conditions
and manner of use which the product will be subjected to in such uses, Ingalls Engineering Co., Inc. makes no warranties, either express or implied,
including any warranty of merchantability or fitness for a particular purpose for use in competition or with specifications or settings other than those
specified by the original manufacturer’s specifications.
For more information on Ingalls products, visit us on the web at www.ingallseng.com
or contact us by calling 1-800-641-9795