Ingalls 93048 - Manual (Page 2)

© Ingalls Engineering Co., Inc. - 2011 Cherry Street, Suite 104 - Louisville, CO, 80027
(800) 641-9795 - (303) 665-7800 - Fax: (303) 665-7810 - www.IngallsEng.com
Step 2: On the front of the engine, locate the 10 mm bolt (Arrow “B”, Illustration 3) and remove. Next, locate the two
8 mm socket head cap screws (Arrows “C”, Illustration 3) and remove. Fit Engine Mounting Bracket onto the front of
the engine and secure using the provided M10 bolt, spacer and 8mm socket head cap screws (the spacer goes
between the bracket and engine with the 10 mm bolt). Tighten the 8mm bolts prior to fully tightening the 10mm bolt.
Illustration 3 Illustration 4
Step 3: The sensor on the front, passenger side of the motor (Arrow “E”, Illustration 5) will need to be moved to the
position shown (Arrow “G”, Illustration 6). Remove the 6mm bolt holding the sensor (Arrow “D”, Illustration 5) then
reinstall the bolt without the sensor in place. Move the sensor as shown using care not to damage any of the wiring
and retain with the OEM 6mm bolt (Arrow “F”, Illustration 6).
Illustration 5 Illustration 6