Hang doors adjust and finish, Sliding door hardware - by pass – Knape&Vogt BYP-275I Series User Manual
Page 3
Advertising
4
5
HANG DOORS
ADJUST AND FINISH
• Cut a continuous slot in bottom of door,
centered as shown below.
• Open quick release latches on brackets.
• Slide door onto carrier screws and close latch.
• Repeat for front door on front rail.
• Adjust door to square with sides of door
opening by rotating carrier adjustment screw.
• Using (#6 x 7/8") screws,
mount door guides
where doors overlap.
SLIDING DOOR HARDWARE - BY PASS
Assembly
Instructions
#310305_B (1112)
1/4"
(0,6 cm)
9/16"
(1,4 cm)
Advertising