Prepare opening mount frame hardware, Mount door hardware, Sliding door hardware - bi-fold – Knape&Vogt BIF-20S Series User Manual

Page 2: Assembly instructions

Advertising
background image

SLIDING DOOR HARDWARE - BI-FOLD

Hmax = Door Height + 2-5/8" • Hmin = Door Height + 1-5/8"

1/8" Min.

(0,3 cm)

5/16" Min.

(0,8 cm)

7/8" - 1-1/8"

(2,2 cm - 2,9 cm)

3/4" - 1-1/2"

(1,9 cm - 3,8 cm)

1

2

3

PREPARE OPENING

MOuNt FRAME HARDWARE

• Using track as a template, mark screw locations.

Important: Place track pivot in track

before securing.

• Drill 1/16" pilot holes and secure

with (#6 x 1-1/4") screws.

(M)

• Install top pivot bracket in track with

screw head on track rails with bracket

end approximately 1" from track end.

For 2-door installation, position pivot

end of track snugly against jamb.

• Center jamb bracket directly

below track in jamb corner.

• Using jamb bracket as a template,

drill 1/16" pilot holes and secure

with (#6 x 1-1/4") screws.

(M)

• Drill 3/8" holes 1-1/4" deep in top and

bottom of the pivot door and top only of

guide door.

• Remove lower pivot screw, tap in pivots

and guides, replace screw.

• To install hinges, place doors side by

side as folded with 1/16" gap.

• Use hinge as template, drill 1/16"

diameter holes and secure with

(#6 x 7/8") screws.

(j)

• Drill 3/16" diameter hole through guide

door at center of width and secure knob

with (#8 x 1-3/4") screw.

(I)

Note: Track length should be at least 1/8" less than the width of the finished opening. If necessary, track may be cut with a fine tooth saw.

When the finished opening is taller than door height, the jamb bracket may be fastened to the side jamb making certain that the screws are secured in a solid material.

A block underneath the jamb bracket is required.

2-Door: Line up track flush against jamb on guide door side.
4-Door: Center track in opening.

MOuNt DOOR HARDWARE

1"

(2,5 cm)

Pivot

Pivote

Guide

Guía

1"

(2,5 cm)

Opening Height

Hauteur Ouverture

Altura Abertura

2-Door Width = 2 x Door Width + 1/2"

4-Door Width = 4 x Door Width + 7/8"

Door Height
Hauteur Porte
Altura Puerta

1/16"

(0,2 cm)

1/16"

(0,2 cm)

1/16"

(0,2 cm)

1/8" Gap Min.

(0,3 cm)

5/16"

(0,8 cm)

5/16"

(0,8 cm)

1"

(2,5 cm)

36"

(91,4 cm)

4.5"

(11,4 cm)

Pivot

Pivote

Assembly

Instructions

#310293_D (1013)

4-Door only

4 portes seulement

Solo para 4 puertas

Pivot / Pivote

Guide / Guía

Advertising