KIA Amanti 2004 - Manual (Page 261)

Maintenance
24 7
1
2
3
4
5
6
7
8
9
Changing the automatic
transaxle fluid
1. Raise and suitably support the
vehicle.
2. Remove the drain plug located at
the bottom of the transaxle pan.
3. After the oil has drained complete-
ly, install a new washer on the
plug, reinstall the drain plug, and
tighten to 290~340 kg•cm (21~24
lb•in, 29~33 N•m).
4. Lower the vehicle.
5. Remove the automatic transaxle
dipstick located near the center of
the engine compartment bulkhead
and, using a funnel, add approxi-
mately 2 liters (2 US quarts) of
automatic transaxle fluid.
Use only the specified automatic
transaxle fluid.
(Refer to
"Recommended Lubricants" later in
this section.)
✽ ✽ NOTICE
Do NOT overfill the automatic
transaxle reservoir. Doing so can
cause a seal “blow out”, loss of fluid,
and damage to the transaxle. If you
overfill the reservoir, you must drain
the excess prior to driving the vehi-
cle. The transaxle will hold 2.5 liters
(2.5 US qt.) when completely empty.
However, it is likely that there will
be fluid left in the transaxle after
draining, especially if the front of
the vehicle was raised to remove the
drain plug.
6. Check the fluid level. If necessary,
add a small amount of fluid and
check the level again. Continue
this process until the level reads
within “HOT” range.
7. Replace the dipstick and properly
dispose of the used transaxle fluid.
WARNING - Lifting your
vehicle
If you raise your vehicle, always
ensure that it is supported at all
four jacking or lift points for the
vehicle. Only if this level of sup-
port is provided can you ensure
that the vehicle will remain sta-
ble and not fall off the jack
stands or other supports. If you
do not provide such support,
the vehicle may fall off the jack
stands, or other supports, caus-
ing serious injury or death.
Opirus CAN 7-1.qxd 7/8/03 2:25 PM Page 24