Derale Performance 12" High Output IP-68 Electric Puller Fan - Manual

INSTALLATION INSTRUCTIONS
HIGH OUTPUT SINGLE RAD FAN
PART # 16918
MOUNTING
1. Position the electric fan against the radiator in the desired location.
2. Take the Plastic Rods provided and install through the four mounting
holes on the shroud pushing them slowly into and through the radiator
core. (See Diagram #2)
Do not use excessive force when pushing Mounting Rods
through radiator core. Excessive force could cause damage to the
radiator fins and/or core. Plastic Rods should not be inserted thru both
the radiator and the condenser cores.
3. Take the 1 x 1 Foam Pads provided and install them onto the Plastic
Rods now protruding through the radiator core. (See Diagram #2)
4. Take the Mounting Clips provided, making sure they are in the correct
direction (Derale writing out) install onto the Plastic Rods and cinch
them until the 1 x 1 Foam Pads are compressed. (See Diagram #2)
5. Cut off the excess Mounting Rods.
Caution:
Please read these instructions completely before beginning installation
Diagram #1
Engine
Puller Fan
Air Flow
Radiator
TOOLS NEEDED
Dyke Pliers
Standard Screw Driver or
5/16” Nut Driver
Drill
5/32” Drill Bit
12V Test Light
Wire Stripper
Crimping Tool
IMPORTANT
This fan assembly is designed for PULLER APPLICATIONS
ONLY Engine side of radiator.
(See Diagram #1)
KIT CONTENTS
QTY. DESCRIPTION
1 Fan Shroud Assembly
4 Mounting Rods
QTY. DESCRIPTION
4 Mounting Clips
4 1x1 Foam Pads
Diagram #2
Mounting Clips
1 x 1
Foam
Pads
Mounting
Rods
16918-InstructionSheet
WIRING
This fan is designed for use on a 12V system. It can be used as a puller fan with the wires configured as indicated below.
Positive 12V Wire (+): Blue
Negative Wire (-): Black
NOTE: To confirm color of positive fan leads see Red/Silver manufacturers label on the electric fan.
20 Amp Fuse
12V (+) Switched
Ignition Source
Chassis
Ground
3
Positive (+)
Electric Fan
2
1
Chassis
Ground
TYPICAL MANUAL SWITCH WIRING
MANUAL SWITCH AND ELECTRICAL
COMPONENTS NOT INCLUDED.
Important: Before beginning reference the
Product Label on the Electric Fan for the factory
fan configuration and Positive fan lead color. If you
wish to configure the Electric Fan opposite of the
factory setting, the Positive (+) and Negative (-)
Electric Fan leads MUST be switched.
Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on
vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the
parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting
the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.
Failure to follow instructions can lead to severe damage and personal injury.
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
Revised-12/9/2011