Derale Performance 14" High Output Curved Blade Electric Puller Fan - Manual

KIT CONTENTS
QTY. DESCRIPTION
1 Electric Fan Assembly
4 Mounting Rod
4 Mounting Clip
4 Mounting Feet
4 1x1 Foam Pad
Please read these instructions completely before beginning installation
TOOLS NEEDED
Standard Screw Driver
12V Test Light
Wire Stripper
Crimping Tool
Dyke Pliers
16110-16112-16114-16142-16136-InstructionSheet
INSTALLATION INSTRUCTIONS
H.O. EXTREME ELECTRIC FAN KIT
PART # 16110, 16112, 16114, 16142 & 16136
IMPORTANT
This fan assembly is designed for PULLER (engine
side) applications only.
ELECTRIC FAN MOUNTING
Note: This Electric Fan Assembly requires 4 mounting positions. Four
Mounting Rods will be installed with the 4 supplied Mounting Feet. (See
Diagram #2)
1. Identify the 4 Mounting Feet supplied and install onto the Electric Fan
Assembly by sliding them into the slots on the Electric Fan Assembly.
See Diagram #2
2. Position the electric fan against the radiator in the desired location.
3. Take the Plastic Rods provided and install
through the mounting holes on the shroud
pushing them slowly into and through the
radiator core.
Do not use excessive force when
pushing Plastic Rods through radiator core.
Excessive force could cause damage to the
radiator fins and/or core. Plastic Rods should
not be inserted thru both the radiator and the
condenser cores.
4. Take the 1 x 1 Foam pads provided and install
them onto the Plastic Rods now protruding
through the radiator core.
5. Take the Plastic Clips provided, making sure
they are in the correct direction (Derale writing
out) install onto the Plastic Rods and cinch them
until the 1 x 1 Foam Pads are compressed.
6. Cut off the excess Plastic Rod.
Caution:
Diagram #2
Mounting
Clips
1 x 1
Foam
Pads
Mounting
Feet
Mounting
Rods
Diagram #1
Engine
Puller Fan
Air Flow
Radiator
WIRING
This fan is designed for use on a 12V system. It can
be used as a puller fan with the wires configured as
indicated below.
Positive 12V Wire (+): Blue
Negative Wire (-): Black
(Part # 16110: Blue)
20 Amp Fuse
12V (+) Switched
Ignition Source
Chassis
Ground
3
Positive (+)
Electric Fan
2
1
Chassis
Ground
TYPICAL MANUAL SWITCH WIRING
MANUAL SWITCH AND ELECTRICAL
COMPONENTS NOT INCLUDED.
Important: Before beginning reference the
Product Label on the Electric Fan for the factory
fan configuration and Positive fan lead color. If you
wish to configure the Electric Fan opposite of the
factory setting, the Positive (+) and Negative (-)
Electric Fan leads MUST be switched.
Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on
vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the
parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting
the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.
Failure to follow instructions can lead to severe damage and personal injury.
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com