Derale Performance 5" Tornado Electric Puller Fan, Premium Mounting Kit - Manual

KIT CONTENTS
QTY. DESCRIPTION
1 Electric Fan Assembly
4 Mounting Rod
4 Mounting Clip
4 1x1 Foam Pad
1 Manual Switch
7ft 14 Gauge Wire
1 20 Amp Fuse Holder
QTY. DESCRIPTION
3 Blue Female Connector
1
2
#10 Blue Ring Terminal
3 Blue Butt Connector
4 #10 x 1/2” Sheet Metal Screws
4 4” Zip Ties
Blue Wire Tap Connector
Please read these instructions completely before beginning installation
TOOLS NEEDED
Standard Screw Driver
Drill
5/32” Drill Bit
12V Test Light
Wire Stripper
Crimping Tool
Dyke Pliers
Puller Fan Pusher Fan
Air Flow
Engine Radiator
16504-16505-InstructionSheet.cdr
INSTALLATION INSTRUCTIONS
TORNADO ELECTRIC FAN KIT
PART # 16504 & 16505
IMPORTANT
This fan assembly is designed for PULLER applications only.
(See Diagram #1)
(Continues on Page 2)
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
ELECTRIC FAN MOUNTING
Note:
Caution:
This Electric Fan Assembly requires 4 mounting positions (Part# 16505 requires 3 mounting positions). (See Diagram #2)
1. Position the electric fan against the radiator in the desired location.
2. Take the Plastic Rods provided and install through the mounting holes on the shroud pushing them slowly into and through
the radiator core.
Do not use excessive force when pushing Plastic Rods through radiator core. Excessive force could cause
damage to the radiator fins and/or core. Plastic Rods
should not be inserted thru both the radiator and the
condenser cores.
3. Take the 1 x 1 Foam pads provided and install them
onto the Plastic Rods now protruding through the
radiator core.
4. Take the Plastic Clips provided, making sure they are in
the correct direction (Derale writing out) install onto the
Plastic Rods and cinch them until the 1 x 1 Foam Pads
are compressed.
5. Cut off the excess Plastic Rod.
Diagram #2
Mounting Clips
1 x 1
Foam
Pads
Mounting
Rods
Diagram #1