Derale Performance Tornado Electric Fan & Thermostat Kit - Manual

KIT CONTENTS
QTY. DESCRIPTION
1 Electric Fan
4 Mounting Rods
4 Mounting Clips
5 1x1 Foam Pads
1 Thermostat Switch
1 7 Ft. 14 Ga. Wire
1 3/8” NPT Thread-in Probe
1 Push-in Probe
QTY. DESCRIPTION
1 Retaining Probe Clip
1 Blue 5/16” Ring Terminal
2 Blue #10 Ring Terminal
1 Blue Butt Connectors
2 Blue Female Connectors
2 Blue Wire Tap Connectors
4 4” Wire Ties
2 #10 Sheet Metal Screw
Please read these instructions completely before beginning installation
TOOLS NEEDED
12V Test Light
Wire Stripper
Crimping Tool
3/4” Wrench
Teflon Tape
Standard Screw Driver
or a 5/16” Nut Driver
Puller Fan Pusher Fan
Air Flow
Engine Radiator
16504-16505-InstructionSheet.cdr
INSTALLATION INSTRUCTIONS
TORNADO ELECTRIC FAN & THERMOSTAT KIT
PART # 16004 & 16005
IMPORTANT
This fan assembly is designed for PULLER applications only.
(See Diagram #1)
(Continues on Page 2)
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
ELECTRIC FAN MOUNTING
Note:
Caution:
This Electric Fan Assembly requires 4 mounting positions (Part# 16505 requires 3 mounting positions). (See Diagram #2)
1. Position the electric fan against the radiator in the desired location.
2. Take the Plastic Rods provided and install through the mounting holes on the shroud pushing them slowly into and through
the radiator core.
Do not use excessive force when pushing Plastic Rods through radiator core. Excessive force could cause
damage to the radiator fins and/or core. Plastic Rods
should not be inserted thru both the radiator and the
condenser cores.
3. Take the 1 x 1 Foam pads provided and install them
onto the Plastic Rods now protruding through the
radiator core.
4. Take the Plastic Clips provided, making sure they are in
the correct direction (Derale writing out) install onto the
Plastic Rods and cinch them until the 1 x 1 Foam Pads
are compressed.
5. Cut off the excess Plastic Rod.
Diagram #2
Mounting Clips
1 x 1
Foam
Pads
Mounting
Rods
Diagram #1
Drill
5/32” Drill Bit
Dyke Pliers