S&B Filters Cast Aluminum Intake Elbow 76-1010 - Manual (Page 2)

15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
Installation Instructions (continued)
18.
Position the upper T-bolt clamps as to
not hit the hood when closed and torque them
both to 90In.lbs.
14.
Place the other supplied T-bolt clamp (I)
over the end of the Straight coupler (H) .
16.
Install the other O-ring (B) in the top
groove of the Billet Spacer (A) . Insert the S&B
Elbow (C) into the Straight coupler (H) and
align the mounting holes with the Billet
spacer. Be sure both mating surfaces are
clean.
17.
Insert the M6x30mm Bolts (F) and
M6x93mm Bolts (E) in the proper locations
and torque to 100 In.lbs.
19.
Reinstall the Intake or OE air cleaner
and filter removed in Step 3.
2
20.
Align the upper fan shroud and snap it
back into place if it was removed.
21.
Reconnect both batteries. Inspect your
installation, make sure the elbow and boost
tube is properly positioned and all fasteners
are secure. The installation is now complete.
SEE EXPLODED VIEW ON PAGE 3
11.
Place one the supplied T-bolt camps (I)
over the Straight Coupler (H) and slide it on
the upper end (Large diameter) of the Boost
Tube
(J) .
10.
Place the 2 OE clamps over the Hump
Coupler (K) and slide the coupler over the
lower flange of the intercooler.
12.
Snake the Boost tube assembly into
position and into the Hump coupler (K) .
13.
Position the OE clamps and torque
them to 106 In.lbs.
P/N: 76-1010 / 76-1010B
15.
Clean the intake manifold surface. Then
install the Billet Spacer (A) and the O-ring (B)
onto the intake manifold using 3 supplied
M6x30mm bolts
(F) and 6mm washers (D) .
Torque to 100 In.lbs.