S&B Filters Cast Aluminum Intake Elbow 76-1010 - Manual (Page 3)

15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
Installation Instructions (continued)
3
P/N: 76-1010 / 76-1010B
Warranty
Visit www.sbfilters.com/Support/Why-S-B/Million-Mile-Limited-Warranty for S&B Filterʼs complete warranty.
ITEM QTY. DESCRIPTION P/N
A 1 Billet Spacer Block AL1208-00
B 2 O-Ring AI1591-00
C 1 Intake Elbow, White or Black AL1099-00
D 7 Washer, S.S. Flat, 6mm AI1416-00
E 1 M6-1.0x93mm, Hex Head Screw AI1413-00
F 6 M6-1.0x30mm, Hex Head Screw AI1414-00
G 3 Plug, Socket, 1/8”NPT AI1398-00
H 1 Coupler, Silicone 3.5”IDx3.25” AI1394-00
I 2 T-bolt Clamp, 92.2-100mm AG1027-00
J 1 Boost Tube, Alum. AL1102-00
K 1 Coupler, Hump Silicone 3”IDx4” AI1395-00
AM0
1
9
5
-0
0
R
e
v.
A
0
2
/0
5
/1
3
Emissions Standard
The California Air Resource Board (CARB) requires that an E.O. identification label be applied to the vehicle in order to pass a smog check inspection when a
Performance Intake Kit has been installed. You must place the E.O. label provided on or near the intake kit after installation so that a smog check technician can
easily verify the E.O. number. As of April 2009, S&B has never had a product where CARB denied an exemption request; however, the exemption process with
CARB can take as long as 18 months. Check the status of the exemption process by looking up a specific part number at
www.sbfilters.com . The CARB Exemption
number and/or status is listed under the Product Details section for each part number. If the status shows as “Pending,” CARB has yet to issue an exemption.
Products that have not been issued an EO number are street legal in most states, but may not be used on emission controlled vehicles in the state of California and
are for off road use only. If you purchased your kit from S&B Filters directly, we will automatically mail you your Exemption Sticker when it is issued to us. If you
purchased your kit from an authorized S&B Filters Dealer, log onto our web site and register to receive your Exemption Sticker.
Testing and Maintenance
• Engage parking brake and start your engine. Listen for abnormal noises. If an air leak is
detected, re-inspect hoses and connections as they may need to be repositioned and
tightened.
• S&B Filters recommends that you keep your OE intake system in the event it is required in
the future.
• In order to maintain your warranty, all connections and components must be checked
periodically for alignment and for proper tension on all connections every 6-12 months.
Failure to do so may void your warranty.
• Use only S&B FILTERS cleaning and oil products to service your filter. Using any other
brand oil and or cleaners on your S&B air filter will void your warranty.