Installation instructions (continued) – S&B Filters Cold Air Intake Kit - Cotton Filter 75-5066 User Manual
Page 2
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -
www.sbfilters.com
Installation Instructions (continued)
10.
Insert the Air Inlet tube
(S)
onto the Air
Box
(M)
and secure using the supplied
1/4”-20x3/4” screws
(V)
, 1/4” Lock washers
(U)
and 1/4” Flat washers
(W)
.
14.
Using the OE bolt, secure the air box
assembly to the frame. Leave loose for now..
19.
Install the Clear Lid
(N)
using the supplied
1/4-20x1.25” Screws
(Q)
and Rubber Washers
(R)
along with the 1/4-20x5/8” Screws
(P)
and
Rubber Washers
(Q)
. This will secure the Filter
Adapter to the Air Box as well.
(Do not over
tighten!)
13.
Carefully install the air box assembly
into the truck at an angle as shown below."
15.
From inside the wheel well, attach the
air box to frame using the supplied M8 x
40mm Hex bolt
(K)
and Fender Washer
(L)
.
Then secure both bolts mounting the air box
to the frame.
16.
Reinstall the wheel liner using 5 of the
OE screws and 3 supplied Panel Pins
(Y)
.
Reinstall wiring harness connector into wheel
liner that was removed in Step #7.
17.
Secure the wheel liner to the air box
using two supplied 1/4”-20x3/4” screws
(V)
and Flat washers
(W)
inside the air box. Use
the 1/4” Nylock nuts
(X)
and 1/4” Flat washers
(W)
under the wheel liner.
SEE EXPLODED VIEW ON PAGE 4
2
P/N: 75-5066 / 75-5066D
18.
Insert the S&B Filter
(J)
onto the Adapter
Tube
(H)
and secure the #104 Hose Clamp
(I)
. Install the assembly into the Air box. Then
push the valve cover breather hose onto the
stem of the Adapter tube.
11.
For those concerned about minimal engine heat; insert the Air Inlet Plug
(T)
into the end of the
Air Inlet tube
(S)
. Attach using the supplied 1/4”-20x3/4” screws
(V)
, 1/4” Lock washers
(U)
and 1/4”
Flat washers
(W)
. For those seeking additional air flow, set the Air Inlet Plug aside and save all the
supplied hardware.
(See page 3 for more info and test results)
12.
NOTE:
Vehicles equipped with 4x4 can
use the provided Screw Cap
(O)
. Cut down
and place on top of bolt accordingly to protect
the S&B Air Box. "
"
20.
Note the OE Temp. Sensor orientation.
Then carefully pull it out of the OE tube. Insert
the supplied Grommet
(D)
into the Intake
Tube
(E)
. Carefully push the Temp. sensor
into the grommet using a twisting motion. Be
sure to match the OE orientation.