S&B Filters Cold Air Intake Kit - Cotton Filter 75-9006 - Manual (Page 3)

7
7/2/2012
REV- C
INSTALLATION INSTRUCTIONS
(continued)
INSTALLATION INSTRUCTIONS
(continued)
27. Reconnect the MAF sensor electrical
connection.
28. Reconnect the coil wire to the ignition coil.
And electrical connections if removed.
29. Install the S&B filter into the S&B air box as
shown below.
28. Secure the filter to the flange with the hose
clamp.
29. Place the clear lid on the S&B air box and
use the supplied SS hardware to secure.
30. Reconnect the battery ,Inspect your instal-
lation, make sure kit is properly positioned and
all fasteners are secure.
31. Affix the C.A.R.B. sticker in plain sight
under the hood near the intake system. Your
installation is now complete.
Smog Certification Note:
The California Air Resource Board
(CARB) requires that an E.O.
identification label be applied to the
vehicle in order to pass a smog
check inspection when a High
Performance Intake Kit has been
installed.
You must place the E.O. label
provided on or near the intake kit
after installation so that a smog
check technician can easily verify
the E.O. number.
PERFORMANCE TESTING
∗ Engage parking brake and start your
engine. Listen for abnormal noises. If an
air leak is detected, re-inspect hoses and
connections as they may need to be
repositioned and tightened.
∗ S&B FILTERS recommends that you
keep your OE intake system in the event
it is required in the future.
∗ In order to maintain your warranty, all
connections and components must be
checked periodically for alignment and
for proper tension on all connections.
Failure to do so may void your warranty.
∗ Use only S&B FILTERS cleaning and oil
products to service your filter. Using any
other brand oil and or cleaners on your
S&B air filter may void your warranty.
787 S. Wanamaker Ave, Ontario, CA 91761
(909) 947-0015 Phone • (909) 947-0603 Fax
www.sbfilters.com