S&B Filters Cold Air Intake Kit - Cotton Filter 75-5032 - Manual (Page 2)

787 S. Wanamaker, Ontario, CA 91761 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
INSTALLATION INSTRUCTIONS (continued)
9.
Prior to installing the Air Box (L) , you may
need to rotate the factory intercooler clamp
that is located just below the OE air box to
add clearance for the new one.
NOTE: If you have the OE “Two
Piece” intake tube pictured in step #5(A)
you will skip steps #12 thru #16, resume
at the note prior to step #17.
15.
Insert the Short Tube (S) assembly into
the Straight Adapter (T) , align the breather
tube then secure using a #64 hose clamp (G) .
10 (A).
Grease the prongs on the bottom of the
Air Box (L) and place the box in the vehicle. Tilt
towards the front, align mounting hole over the stud
in the core support. Then push down on the Air Box
to seat the prongs into the OE grommets. Use
Washer
(M) and Lock Nut (N) to secure the air box.
12.
Install the Straight Adapter (T) to the
turbo flange, secure using a #64 Hose Clamp
(G) .
16.
Insert the OE breather tube assembly
into the valve cover.
10 (B).
NOTE: If you do not seat the air
box properly in the OE saddle and grommets,
there will be an interference between the air
box and the hood when the hood is closed.
Check for clearances before you proceed.
13.
Spread the OE clamp open and remove
the breather tube assembly from the OE
intake tube.
Temp. Sensor NOTE:
If your vehicle uses a Temp. Sensor in place of a MAF Sensor: Use
the supplied MAF Block Off Plate (Q) , 8/32 Screws (C) and Washers (B) and Gasket (E) in place of
the MAF sensor. You will also need to drill a 5/8” hole at the drill point on the tube, located opposite
of the MAF port. Remove the OE Temp. Sensor and OE grommet and insert the grommet into the
5/8” hole you drilled in the Intake Tube Adapter
(J) followed by the Temp Sensor. Continue with step
#19.
11.
Carefully place the Air Filter (O) into the
Air Box (L) .
14.
Install the large Grommet (R) into the
Short Tube (S) followed by the 90 degree OE
breather tube fitting.
SEE EXPLODED VIEW ON PAGE 5
2
P/N: 75-5032 / 75-5032D
Loosen Clamp
Grommet
Drill 5/8” hole here for
Temp. Sensor only.
* Clean tube of any debris
before installation.