S&B Filters Cold Air Intake Kit - Cotton Filter 75-5032 - Manual (Page 3)

787 S. Wanamaker, Ontario, CA 91761 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
INSTALLATION INSTRUCTIONS (continued)
SEE EXPLODED VIEW ON PAGE 5
3
P/N: 75-5032 / 75-5032D
23.
Secure the Air Filter (O) to the Intake
Tube Adapter (J) using the #72 Hose Clamp
(D) .
18.
Use the supplied MAF Gasket (E) and
8/32 screws (C) to attach the MAF sensor to
the Intake Tube Adapter (J) , Do not over
tighten!
22.
Secure the adapter to the box using the
5/16 washers (I) and Bolts (H) .
21.
Attach the Intake Tube Adapter (J) to the
Air Box (L) . Clip the adapter to the box and
insert the tube into the Air Filter (O)
simultaneously.
19.
Slip the Hump Adapter (F) along with
two #72 hose clamps (D) over the Intake
Tube Adapter (J) until nearly flush with the
end.
20.
Place the Intake Tube Adapter (J) in the
vehicle as shown, then rotate the tube so the
MAF or Block Off Plate is facing up.
26.
Insert the OE restriction gauge into the
Air Box (L) , then reconnect to the harness.
NOTE: DO NOT rely on the OE restriction
gauge or wait until the dash light is triggered
before you service your S&B air filter.
25.
Reconnect the electrical connector to
either the MAF sensor located on top of the
tube or Temp. Sensor located underneath.
24.
Slide the Hump Adapter (F) over the
turbo inlet tube, center over the gap and
secure both #72 Hose clamps (
D) .
28.
Remove the protective film from the
Clear Lid (P) and place it on the Air Box (L) ,
secure using the 10/24 SS Screws (A) and
SS Sealing Washers (B) .
27.
Reconnect the radiator overflow tube to
the reservoir.
17.
Use the supplied T-20 Torx tool and
remove the MAF sensor from the OE intake.