S&B Filters Cold Air Intake Kit - Cotton Filter 75-2519-3 - Manual

5/23/2008
REV-C
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
(Over)
S&B P/N 75-2519-3
1996-2004 Ford
Mustang GT (except Bullet)
4.6L V8
(909) 947-0015 Phone • (909) 947-0603 Fax
www.sbfilters.com
Qty. Description Qty. Description
1 Straight Adapter 1 Air Filter
1 Step Adapter 4 1/4”-20 X 1” Bolt
1 Intake Tube 1 5/8” x 3.5” Hose
1 Air Box 1 3/4” x 2.25” Hose
1 CARB Sticker 1 1/2” Grommet
1 Aluminum Adapter 2 Acorn Nut
1 #44 Hose Clamp 2 5/16” Jam Nut
TOOLS REQUIRED
7/16” Socket & Ratchet
5/16” Socket or Nut Driver
Phillips Head Screwdriver
Flat Head Screwdriver
13/16” Drill Bit & Drill
(If Applicable)
3 #60 Hose Clamp 2 5/16” Hex Head Screw
2 MAF Sensor Gasket 4 Sealing Washer
4 SS Pan Head Screw
1. With the engine off, disconnect the
negative battery cable.
2. If Equipped: disconnect the separate air
temperature sensor.
3. Disconnect the MAF Sensor.
4. Loosen the OE hose clamp at the throttle
body.
5. Remove the bolt that secures the OE air
cleaner to the inner fender.
6. Disconnect the IAC line from the OE
intake tube.
7. Disconnect the PCV line from the intake
tube.
8. Remove the intake assembly from the
vehicle.
9. Remove the air temperature sensor from
the tube then loosen the hose clamp and
remove the tube from the MAF sensor.
10. Remove the 4 nuts that retain the MAF
sensor and separate it from the air cleaner
housing.
11. Remove the OE screen with the rubber
gasket from the MAF sensor, as this will not
be used with the S&B intake kit.
12. With the hardware provided assemble
the MAF sensor and filter adapter to the air
box, with a gasket on both sides of the air
box opening.
13. Place the S&B step adapter over the
curved end of the S&B tube and secure with
a # 60 hose clamp.