S&B Filters Cold Air Intake Kit - Cotton Filter 75-2519-3 - Manual (Page 2)

5/23/2008
REV-C
PERFORMANCE TESTING
1. Engage parking brake and start
your engine. To ensure that the
system was installed properly,
listen for abnormal noises. If an
air leak is detected, re-inspect
hoses and connections as they
may need to be tightened.
2. S&B FILTERS RECOMMENDS
THAT YOU KEEP YOUR OEM
INTAKE SYSTEM IN THE
EVENT IT IS REQUIRED IN
THE FUTURE.
3. In order to maintain proper war-
ranty, all connections and com-
ponents must be checked peri-
odically for realignment and to
tighten all connections. Failure
to do so will void your warranty.
4. Use only S&B Cleaning and Oil
products to service your filter.
Using another company’s oil
and cleaner products may void
your warranty.
Please call (909) 947-0015
if you have any questions
or comments.
(909) 947-0015 Phone • (909) 947-0603 Fax
www.sbfilters.com
INSTALLATION INSTRUCTIONS
(continued)
Smog Certification Note:
The California Air Resource Board
(CARB) requires that an E.O.
identification label be applied to the
vehicle in order to pass a smog check
inspection when a High Performance
Intake Kit has been installed.
You must place the E.O. label provided
on or near the intake kit after installation
so that a smog check technician can
easily verify the E.O. number.
14. Place the S&B straight adapter over
the other end of the S&B tube and secure
with a #60 hose clamp. 19. IF Equipped: with a separate air
temperature sensor, install the tube and
mark the point where the sensor will be
located. Then remove the tube and drill a
13/16” hole at the mark you made on the
tube, insert the supplied grommet into the
tube.
15. With the hardware provided, assemble
the bolts, fender washers, jam nuts, and
acorn nuts to the S&B air box as shown
below.
16. If the OE grommets came out with the
OE air cleaner assembly place them back in
the original mounting holes located on the
inner fender.
17. Place the S&B air box assembly into
the vehicle at the stock location. Push down
to seat the acorn tipped bolts into the OE
grommets.
18. Place the S&B air filter into the air box
and over the filter adapter, secure the hose
clamp.
20. Install the S&B intake tube to the
throttle body and to the MAF sensor and
secure using the final two #60 hose clamps.
21. Connect the supplied rubber hoses to
the intake tube ports. Then connect the
appropriate lines to the hoses. PCV to the
3/4” hose and the IAC to the 5/8” hose.
22. Place the S&B clear lid onto the air box
and secure with the supplied hardware.
23. Reconnect the negative battery cable
and inspect your installation to ensure the
kit is properly positioned and all fasteners
are secure.