S&B Filters Cold Air Intake Kit - Cotton Filter 75-5067D User Manual
Installation instructions, Vehicle application, Tools required
1.
With the ignition switched off and the
parking brake set, disconnect the negative
battery cable on the passenger side.
Installation Instructions
Vehicle Application
Year: 2011-14
Make: Ford
Model: F150
Engine: 3.5L Ecoboost
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -
3.
The sensor must be removed from the factory intake tube.
4.
Once the sensor is removed from the tube it must be removed from the harness also.
P/N: 75-5067 / 75-5067D
SEE EXPLODED VIEW ON PAGE 6
1
Tools Required
• 8mm, 10mm, 13mm Wrench & Socket
• Pin Removal Tool or Flat Blade Screwdriver
• 7/16” Wrench and Socket
• 5/16” Nut Driver or Flat Blade Screwdriver
• Phillips Screwdriver
• 1 Set of Torx Wrenches & Allen Wrenches
• 1 Pair of Pliers or similar tool
Notes
Kit may not fit with the following
Aftermarket Parts installed:
• Body Lift or Lowering Kit
• Custom Hood
S&B Filter Maintanence
Cleanable
(KF-1058)
. If the enclosed filter is Red, it came pre-oiled
from the factory. Please visit
for the exact oil
amount required after cleaning.
Disposable
(KF-1058D)
. If the enclosed filter is White, it is a
disposable filter and should be discarded once it reaches capacity.
This filter
(does not require oil)
. For more info on S&Bʼs disposable
filter, visit
.
Before You Start
• Please read the entire product guide before proceeding.
• Ensure all components listed on page 4 are present.
• If you are missing any of the components, call our customer support
at (909) 947-0015.
• Do not work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or the
Parking Brake is set.
CARB Status - Pending
Product will be submitted to Air Resources
Board for approval shortly.
Not legal for use in CA or other states
adopting CA emissions standards See
Page 5 for more info.
2.
This vehicle is equipped with one of two different sensors depending on which year your vehicle
is.
5.
With the sensor removed loosen all three
hose clamps that are on the factory intake
tube.
The sensor for the older vehicles
requires a Torx wrench to remove the
sensor from the tube.
On newer vehicles use a pair of pliers
or female Torx to unscrew the bolt and
remove the sensor from the tube.
Older Models 2011
Newer Models 2012-14
(Newer Vehicle Sensor) press down on the
release button and pull out to remove the
sensor from the connector and harness.
(Older Vehicle Sensor) pull the
Red
tab out
and press down on the release button while
pulling out.
Be careful on the removal of the
sensor to not damage the wiring
connections on the harness.
Approx. Install Time 0Hrs 45Min