S&B Filters Cold Air Intake Kit - Cotton Filter 75-5067D - Manual (Page 3)

15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
Installation Instructions (continued)
SEE EXPLODED VIEW ON PAGE 6
3
P/N: 75-5067 / 75-5067D
20.
Once the tube is pushed flush against
the stop hump of the tube the hose clamp (O)
on the cuff can be tightened down.
22.
Once the filter is installed use the correct
adapter plate for the correct model year.
Early Models (U)
2011
Newer Models (V)
2012-14
23.
Install the adapter plate (U) or (V) and
gasket (W) using the two 10-32 screws (G) .
Please make sure that the arrows are aligned
to ensure proper installation.
25.
Note : check to see if your vehicle has a hose connected to the crank case from the intake tube.
If so connect the hose fitting (D) to the crankcase inlet on the S&B intake tube. If not install the socket
plug (K) into the crankcase inlet using the correct Allen wrench (use Teflon tape around which ever
fitting is used).
18.
Install the cuff (R) onto the S&B air box
cover (B) making sure that the tab on the cuff
aligns with the notch on the S&B Air Box
Cover.
19.
Insert the intake tube assembly into the
cuff. Please make sure that the tube is
pushed all the way to the stop hump of the
tube. This will not be an air tight fit to allow for
engine movement.
21.
Flip over the assembly and install the
S&B air filter (Q) and tighten the hose clamp
(N) . Position the clamp so that it can be
accessed through the lid in the future.
24.
Once the adapter plate is connected
install the factory sensor to the plate using the
provided hardware
(J) or (H&I) .
26.
The S&B intake is now ready for
installation.
27.
Place the whole intake assembly and lower it down into the stock intake box. Please make
sure that the tabs on the S&B air box cover fit correctly into slots on the factory box on the right hand
side. Once the tabs are in the slots lower the whole intake assembly into place.