Swanstone BK-326072 - Installation - Manual (Page 15)

Fumes Hazard
The fumes from the sealants and
solvents used by the installer can be
harmful if used in an unventilated room.
Always work in a well-ventilated area.
2. Clean the backs of each panel with denatured
alcohol or another non oil-based cleaning solvent.
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the
panel from adhering properly to the wall.
3. Apply the silicone in 1-1/4” diameter dots 8 to 10
inches apart over the surface of the panel. Follow
the silicone manufacturers’ instructions and note all
ventilation and installation precautions.
4. Place the seat, with the rounded edges facing out,
onto the silicone. Make sure the seat is correctly
positioned and place weight on top of the seat to
hold it firmly in place.
Back Panel
1. Make a template for the bench seat cutout in the
back wall. The side of the box from the kit can be
used to make this template.
2. Cut out the corner of the template larger than the
seat area. Make sure the cardboard is square
against the wall and shower base.
BK-BP-001
BK-BS-002b
IMPORTANT NOTICE
BK-PI-001
WARNING
800-325-7008 15 The Swan Corporation – Swanstone
Installation Procedure