Installation procedure – Swanstone BK-326072 - Installation User Manual
Page 28
Final Caulking
Apply a bead of the color-matched 100% silicone
sealant and white silicone sealant (included in the kit).
Follow the manufacturers’ instructions on the tube for
proper application. Allow at least 24 hours for silicone to
set before using the shower enclosure.
1.
Apply color-matched 100% silicone sealant, as
shown.
2.
Apply white silicone sealant, as shown. This white
silicone sealant is nonpaintable.
The installation is now complete. DO NOT
discard these installation instructions. PLEASE
LEAVE THEM WITH THE HOMEOWNER.
Attaching Shower Doors and Accessories
1.
Follow the mounting instructions that come with
each accessory.
2.
Drill pilot holes, where fasteners pass through the
wall panels slightly larger than the fastener.
3.
If anchors are being used, drill the hole in the panel
large enough for the head of the anchor to fit
through the panel and the structural wall behind it.
4.
Use 100% silicone sealer to seal any holes or joints
between the accessory and the wall panel.
BK-FC-002
BK-FC-001
IMPORTANT NOTICE
The Swan Corporation – Swanstone
28
800-325-7008
Installation Procedure