Dowco Power Sports Iron Rider Modular Luggage - Manual

Please Read! Read all Cautions, Warnings and Notes within installation instructions and on bags. If you are unsure
about securing the bag, please contact us at 1-800-558-7755 ext. 123.
Monday through Friday 8:00am - 4:30 pm C.S.T.
DOWCO Inc.
4230 Clipper Dr.
Manitowoc, WI 54220 USA Phone: 1-800-558-7755
Fax: 920-682-5891
email: [email protected]
I-Sheet 00754
Revised 06/20/07
Page 1
Printed in China
MLS-MB
Main Bag
MLS-RB
Roll Bag
MLS-GB
Garment Bag
MLS-CB
Commuter Briefcase
Installation Instructions For Single Mount Bags:
1. Separate the velcro strap(s) on the back side of the luggage. Lower
the bag onto the luggage rack keeping straps on opposite sides of
the Sissy Bar/Backrest (Fig.1)
2. Be sure the bag is centered and sitting firmly on the luggage rack.
Tighten the velcro straps around the backrest. Fasten velcro straps
to secure the bag.
Note:An additional strap assembly has been provided to aid in
Fig. 1
* Recommended for use with a sissy bar/backrest and luggage rack combination which is perma-
nently attached to the motorcycle. Mount the bag at this location ONLY.
* Do not exceed the manufacturer’s recommended load capacity of the luggage rack or motor-
cycle.
* Consult owner’s manual for tire inflation pressures and gross axle weight rating. Failure to follow
recommended weight loading capacities may affect handling. This may result in injury or property
damage.
* Secure the bag to the vehicle so the bag will not shift during operation.
* Verify that straps do not obstruct exhaust system, reflectors, turn signals, or tail lamp.
* Allowing straps to hang loose may cause damage to packs and/or painted finishes. Hanging
straps may become entangled in the wheel or drive chain or belt resulting in serious personal
injury and/or property damage.
MLS-OB
Overnight Bag
MLS-LRB
Large Roll Bag