Dowco Power Sports Iron Rider Modular Luggage - Manual (Page 2)

4. Locate the zippers on either side at the bottom of the
bag. (Commuter Bag buckles are not contained within a
zippered pocket.) Unzip and pull out the two short straps
with buckles (see Fig. 4). Locate the mounting strap kit
included with the bag. Connect the long mounting straps
to the short straps that are attached to the bag. These
straps use side release buckles to offer quick attachment
and release.
5. Loop the long mounting straps (on both sides of the bag)
around the directional indicator bar (or similar sturdy
mounting area), and connect the final side release buck-
les (see Fig. 5). Be sure the buckle has “snapped” into
place, and the connection is secure.
6. Pull the slack out of the loose end of the strap to tighten.
Excess strap material should be knotted or removed and
end sealed to prevent unravelling. Ensure that your bag
is securely mounted.
7. Periodically check each bag to ensure attachment is
secure as straps may loosen during riding.
Allowing straps to hang loose may cause damage to packs and/or painted
finishes. Hanging straps may become entangled in the wheel or drive chain
or belt resulting in serious personal injury and/or property damage.
DOWCO Inc.
4230 Clipper Dr.
Manitowoc, WI 54220 USA Phone: 1-800-558-7755
Fax: 920-682-5891
email: [email protected]
I-Sheet 00754
Revised 06/20/07
Page 2
Printed in China
Garment Bag only
2a. Connect straps to sides of bag - Hook to one D-ring (Fig. 8). Go under the luggage rack. Secure
to D-ring on opposite side. Pull tight. (Fig.2)
Connect straps to front of bag - Hook to one D-ring (Fig.8). Position down front of bag and under
the luggage rack where accessible and up the other side to opposite D-ring. Pull tight. (Fig. 3)
3. This will complete installation of the Garment Bag and Roll Bag. For completing the installation of
the Main, Overnight, and Commuter Bags continue to Step 4.
Fig. 2 Fig. 3
Fig. 4
Fig. 5