Factory Direct Hardware Von Duprin 98EO - Manual

Installation Instructions
®
98/99
Series Rim Exit Device
This product is covered by the
following patent numbers:
3,767,238 4,427,223
3,854,763 4,466,643
4,167,280 4,741,563
911373_00(4) Copyright © 2005 Ingersoll-Rand. All rights reserved.
Devices covered by these instructions:
98/99 Rim Exit Device
98/99-F (Fire) Rim Exit Device
CD98/CD99 (Cylinder Dogging) Rim Exit Device
98-2/99-2 (Double Cylinder) Rim Exit Device
EL98/EL99 (Electric Latch Retraction) Rim Exit Device
Index:
• Screw chart ................................... 2
• Preparation chart ......................... 3
• Device installation ...................4-5
• Optional equipment ................ 6-7
• Cut device ..................................... 8
• 499F strike installation ............... 8
Special tools needed:
5/64” hex wrench
#10-24 tap
5/8” spade drill (
99-F wood door )
Drill bits: #25, 1/8”, 1/4”,
5/16”, 3/8”, 13/32”
8
9
2
Tape and mark area being cut.
911373-00
CUT DEVICE
Cut device square
and remove all
burrs
1-1/2” minimum clearance
(with endcap removed)
Device aligned
with mounting
holes
3
Cut device square.
NOTE: Device must
be cut square for
proper end cap fit
4
Slide anti-rattle clip into device .
Tape
Cover plate
(flush to pushbar)
Pushbar
Remove anti-rattle clip
1
Measure amount to cut off device.
Anti-rattle
clip
2”
Minimum
499F STRIKE INSTALLATION
Prepare and install screws
through 2 strike slots. 1
3
4
#25 Drill
#10-24 tap
2 places
CL
Roller
(against door)
CL
Install strike hook and
additional strike screws. 2
Template aligns as shown.
3
1/16”
Strike
hook
If using a mullion, holes
may be predrilled
CL
Template
(align on C and
against strike)
L
If 5/8” diameter wire access hole
has been predrilled in door, cut
device 5/16” from center of hole.
Note
5/16”
Please give these instructions to building owner after device is installed
#25 Drill
#10-24 tap
2 places Metal
W
ood
13/32” Drill
thru for
sex bolts
2 places
#25 Drill
#10-24 tap
3 places