Factory Direct Hardware Hansgrohe 38117 - Manual (Page 4)

4
Install the new cup washers and springs in the rough.
Install the cartridge assembly.
Installation with 38111181 rough manufactured after 04/2004
Remove the covers from the plaster shields.
Trim the plaster shields so that they extend 1/16”
outside the surface of the finished wall. Seal the wall
around the plaster shield with waterproof sealant.
Use a 17 mm socket wrench to remove the spout plug.
Use a 7 mm socket wrench to remove the cartridge
housing. Remove and discard the flush insert.
Turn the water off at the supply before
beginning this installation.
1.
2.