Baldwin Stonegate Handleset - Manual (Page 10)

Handleset Installation (cont.) 3
11
Rotate deadbolt cam
toward door edge using a flat
head screwdriver. This will cover
the mounting screw hole that is
closest to door edge.
12
Keeping tailpiece vertical,
insert cylinder tailpiece through
outside handle assembly, dead-
bolt, and emergency exit car-
tridge.
14
With turn knob in vertical
position, align the slot in back of
turn knob with tailpiece and
place interior escutcheon plate
against door. Fasten with two
(four for rectangular interior
escutcheon plate) #6-32 x
7 ⁄
16
"
oval head screws.
15
Pull spindle out as far as
possible and depress thumbpiece.
Slide knob/lever onto spindle and
tighten set screw firmly into V
groove with Allen wrench. Tighten
#10-32 x 2
1 ⁄
2
" flat head screw.
Attach bottom screw cover.
The lever version of this prod-
uct comes with both left-hand
and right-hand levers. You will
only use one in the installa-
tion. To determine which lever
to use, make sure that the han-
dle portion of the lever extends
toward the hinges of the door
and the hole for the set screw
faces down.
Lever Version
13
From inside of door, rotate
tailpiece to retract deadbolt and
uncover blocked mounting hole at
top of cartridge. Attach cylinder
with two #10-32 x 1
7 ⁄
8
" flat head
screws. Tighten all four screws
making certain assembly is
aligned properly. Check operation
of tailpiece and spindle.
inside inside inside inside inside
Tailpiece
vertical
Door edge
Mounting screw
hole is covered
If you have any trouble installing your Baldwin product, feel free to call our toll-free consumer help line at 1-800-566-1986. Hours: 6 a.m. – midnight (east coast standard), 7 days a week. 10.