Baldwin Stonegate Handleset - Manual (Page 6)

3
Fold hole template along
door edge with center of bot-
tom hole (A), the 2
1 ⁄
8
" dia.
hole, 38" from floor. Tape tem-
plate to door.
4
Determine backset, which
is the distance from the edge of
door to center of hole. Use
hole template to mark the
backset center point for your
installation. Locate and mark
positions for (A, B, C, D, and
E) on template. The most
common backset is 2
3 ⁄
8
".
5
Very carefully drill (A, B)
2 1 ⁄
8
" holes into one side of door
face until drill bit starts to
protrude on opposite side.
Important: Drill perpendicu-
larly (at a 90º angle) to door.
1
Pull door toward you to
check if it’s level. Observe con-
tact of door to jam and make
sure it’s level. Adjust if neces-
sary.
Door Preparation (If Needed) 2
hole template
low side of bevel
door stop
B
A
top of door
2
(Aerial View) To ensure
proper alignment, only use
hole template on side facing
doorstop.
Helpful Hint: Some doors
have a beveled edge with bevel
facing doorstop.
If you have any trouble installing your Baldwin product, feel free to call our toll-free consumer help line at 1-800-566-1986. Hours: 6 a.m. – midnight (east coast standard), 7 days a week. 6.