Baldwin Stonegate Handleset - Manual (Page 8)

Handleset Installation 3
1
Determine your backset,
which is the distance from
the edge of door to center of
hole. Your lockset is shipped
with a 2
3 ⁄
8
" backset (most
common). Adjust for a 2 3 ⁄
4
"
backset door only.
3
Insert latch with angled side of
bolt facing outside. Drill 1 ⁄
8
" pilot
holes. Secure with two #8 x 3 ⁄
4
"
combination screws so latch is
flush with door. Repeat for dead-
bolt.
Helpful Hint: When installing
wood screws it is recommended to
put beeswax or soap on screw
threads to improve installation.
2
For a 2 3 ⁄
4
" backset, grasp
body and twist faceplate 180º
until it stops. Angled side of
bolt should face outside.
Follow same procedure for
deadbolt.
Note: See deadbolt orientation
during installation step 4.
4
Note orientation of dead-
bolt. Insert deadbolt. Drill 1 ⁄
8
"
pilot holes. Secure with
#8 x
3 ⁄
4
" combination screws so
latch is flush with door.
inside inside
5
Extend deadbolt using
flat head screw driver.
inside
Top
If you have any trouble installing your Baldwin product, feel free to call our toll-free consumer help line at 1-800-566-1986. Hours: 6 a.m. – midnight (east coast standard), 7 days a week. 8.