Factory Direct Hardware Hansgrohe 06117 - Manual (Page 5)

5
Install the connecting hoses
Push a compression nut and ferrule over the
end of the connecting hose.
Push the end of the hose into the outlet port
on the valve.
Tighten the compression nut wrench tight.
Do not allow the connecting hose to twist, or
it will become loosened from the spout.
Repeat with the second connection hose.
Install the handles
Retroaktiv widespread
only: Install the deco rings on
the handles.
Install the pull rod
The Retroaktiv Tango and Limbo pull rods are
straight.
The Interaktiv and Retroaktiv Swing pull rods
are curved. These rods should be installed
with the curve as shown in the diagram.
Install the pop up drain.
Install the supply lines (not included).
Turn on the water and check for leaks.
All models: Hold the lever
or cross part of the handle in the desired
“off” position with one hand. With the
other hand, turn the bell part of the handle
clockwise, so that it threads down over the
valve stem.