Factory Direct Hardware Hansgrohe 38020 - Manual (Page 3)

3
Installation
Place the faucet and sealing ring on the mounting
surface.
Install the friction washer, metal washer, and mounting
nut.
Tighten the mounting nut by hand.
Check the position of the faucet. When satisfied, use
a slot-headed screwdriver to tighten the tensioning
screws.
Connect the hot and cold supply lines to the stops.
Use two wrenches, as shown in the
diagram, to prevent hose twisting.
Install the drain.
Set the high temperature limit stop (optional).
Turn on the water and check all connections for leaks.
Install the drain pull
rod.